FreeBSD manual
download PDF document: altera_sdcard.4.pdf
ALTERA_SDCARD(4) FreeBSD Kernel Interfaces Manual ALTERA_SDCARD(4)
NAME
altera_sdcard - driver for the Altera University Program Secure Data Card
IP Core
SYNOPSIS
device altera_sdcard
In /boot/device.hints:
hint.altera_sdcardc.0.at="nexus0"
hint.altera_sdcardc.0.maddr=0x7f008000
hint.altera_sdcardc.0.msize=0x400
DESCRIPTION
The altera_sdcard device driver provides support for the Altera
University Program Secure Data Card (SD Card) IP Core device. A
controller device, altera_sdcardcX, will be attached during boot.
Inserted disks are presented as disk(9) devices, altera_sdcardX,
corresponding to the controller number.
HARDWARE
The current version of the altera_sdcard driver supports the SD Card IP
core as described in the August 2011 version of Altera's documentation.
The core supports only cards up to 2G (CSD 0); larger cards, or cards
using newer CSD versions, will not be detected. The IP core has two key
limitations: a lack of interrupt support, requiring timer-driven polling
to detect I/O completion, and support for only single 512-byte block read
and write operations at a time. The combined effect of those two limits
is that the system clock rate, HZ, must be set to at least 200 in order
to accomplish the maximum 100KB/s data rate supported by the IP core.
SEE ALSO
disk(9)
Altera University Program Secure Data Card IP Core, Altera Corporation -
University Program,
ftp://ftp.altera.com/up/pub/Altera_Material/11.0/University_Program_IP_Cores/Memory/SD_Card_Interface_for_SoPC_Builder.pdf,
August 2011.
HISTORY
The altera_sdcard device driver first appeared in FreeBSD 10.0.
AUTHORS
The altera_sdcard device driver and this manual page were developed by
SRI International and the University of Cambridge Computer Laboratory
under DARPA/AFRL contract (FA8750-10-C-0237) ("CTSRD"), as part of the
DARPA CRASH research programme. This device driver was written by Robert
N. M. Watson.
BUGS
altera_sdcard contains a number of work-arounds for IP core bugs.
Perhaps most critically, altera_sdcard ignores the CRC error bit returned
in the RR1 register, which appears to be unexpectedly set by the IP core.
altera_sdcard uses fixed polling intervals are used for card
insertion/removal and I/O completion detection; an adaptive strategy
might improve performance by reducing the latency to detecting completed
I/O. However, in our experiments, using polling rates greater than 200
FreeBSD 14.0-RELEASE-p11 August 18, 2012 FreeBSD 14.0-RELEASE-p11