FreeBSD manual
download PDF document: if_qlxgb.4.pdf
QLXGB(4) FreeBSD Kernel Interfaces Manual QLXGB(4)
NAME
qlxgb - QLogic 10 Gigabit Ethernet & CNA Adapter Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device qlxgb
To load the driver as a module at boot time, place the following line in
loader.conf(5):
if_qlxgb_load="YES"
DESCRIPTION
The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum
offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further
hardware information, see http://www.qlogic.com/.
HARDWARE
The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the
following chipsets:
o QLogic 3200 series
o QLogic 8200 series
SUPPORT
For support questions please contact your QLogic approved reseller or
QLogic Technical Support at http://support.qlogic.com, or by E-mail at
<support@qlogic.com>.
SEE ALSO
altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The qlxgb device driver first appeared in FreeBSD 10.0.
AUTHORS
The qlxgb driver was written by David C Somayajulu at QLogic Corporation.
FreeBSD 14.0-RELEASE-p6 November 3, 2011 FreeBSD 14.0-RELEASE-p6