FreeBSD manual
download PDF document: if_qlxge.4.pdf
QLXGE(4) FreeBSD Kernel Interfaces Manual QLXGE(4)
NAME
qlxge - QLogic 8100 Series 10 Gigabit Ethernet Adapter Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device qlxge
To load the driver as a module at boot time, place the following line in
loader.conf(5):
if_qlxge_load="YES"
DESCRIPTION
The qlxge driver supports IPv4 checksum offload, TCP and UDP checksum
offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further
hardware information, see http://www.qlogic.com/.
HARDWARE
The qlxge driver supports 10 Gigabit Ethernet & CNA Adapter based on the
following chipsets:
o QLogic 8100 series
SUPPORT
For support questions please contact your QLogic approved reseller or
QLogic Technical Support at http://support.qlogic.com, or by E-mail at
<support@qlogic.com>.
SEE ALSO
altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The qlxge device driver first appeared in FreeBSD 10.0.
AUTHORS
The qlxge driver was written by David C Somayajulu at QLogic Corporation.
FreeBSD 14.0-RELEASE-p6 June 21, 2013 FreeBSD 14.0-RELEASE-p6