FreeBSD manual
download PDF document: ng_frame_relay.4.pdf
NG_FRAME_RELAY(4) FreeBSD Kernel Interfaces Manual NG_FRAME_RELAY(4)
NAME
ng_frame_relay - frame relay netgraph node type
SYNOPSIS
#include <netgraph/ng_frame_relay.h>
DESCRIPTION
The frame_relay node type performs encapsulation, de-encapsulation, and
multiplexing of packets using the frame relay protocol. It supports up
to 1024 DLCI's. The LMI protocol is handled by a separate node type (see
ng_lmi(4)).
The downstream hook should be connected to the synchronous line, i.e.,
the switch. Then hooks dlci0, dlci1, through dlci1023 are available to
connect to each of the DLCI channels.
HOOKS
This node type supports the following hooks:
downstream The connection to the synchronous line.
dlciX Here X is a decimal number from 0 to 1023. This hook
corresponds to the DLCI X frame relay virtual channel.
CONTROL MESSAGES
This node type supports only the generic control messages.
SHUTDOWN
This node shuts down upon receipt of a NGM_SHUTDOWN control message, or
when all hooks have been disconnected.
SEE ALSO
netgraph(4), ng_lmi(4), ngctl(8)
HISTORY
The ng_frame_relay node type was implemented in FreeBSD 4.0.
AUTHORS
Julian Elischer <julian@FreeBSD.org>
BUGS
Technically, frames on DLCI X should not be transmitted to the switch
until the LMI protocol entity on both ends has configured DLCI X as
active. The ng_frame_relay node type ignores this restriction, and will
always pass data received on a DLCI hook to downstream. Instead, it
should query the LMI node first.
FreeBSD 14.0-RELEASE-p11 January 19, 1999 FreeBSD 14.0-RELEASE-p11