FreeBSD manual
download PDF document: oce.4.pdf
OCE(4) FreeBSD Kernel Interfaces Manual OCE(4)
NAME
oce - Device driver for Emulex OneConnect 10Gb network adapters
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device pci
device oce
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_oce_load="YES"
DEPRECATION NOTICE
The oce driver may not be present in FreeBSD 15.0 and later.
DESCRIPTION
Emulex OneConnect adapters come in various skews and with different
combinations of NIC, FCoE and iSCSI functions. The oce driver claims the
NIC functions in all these adapters.
The oce driver supports VLAN Hardware offload, TCP checksum offload, TCP
segmentation offload (TSO), Large receive offload (LRO), Bonding, Jumbo
frames (from 1500 - 9000), Multiple TX queues, Receive-Side Scaling (RSS)
and MSI-X interrupts.
HARDWARE
The oce driver supports the following network adapters:
o Emulex BladeEngine 2
o Emulex BladeEngine 3
o Emulex Lancer
UPDATING FIRMWARE
Adapter firmware updates are persistent.
Firmware can be updated by following the steps below:
1. Copy the below code to a Makefile:
KMOD=elxflash
FIRMWS=imagename.ufi:elxflash
.include <bsd.kmod.mk>
2. Replace imagename in above with UFI file name
3. Copy Makefile and UFI file to a directory
4. Execute make & copy generated elxflash.ko to /lib/modules
5. sysctl dev.oce.<if_id>.fw_upgrade=elxflash
6. Reboot the machine
In case of issues with supplied UFI, flashing fails with one of the
For general information and support, go to the Emulex website at:
http://www.Emulex.com/ or E-Mail at freebsd-drivers@emulex.com.
SEE ALSO
ifconfig(8)
AUTHORS
The oce driver was written by freebsd-drivers@emulex.com.
FreeBSD 14.0-RELEASE-p11 June 13, 2023 FreeBSD 14.0-RELEASE-p11