FreeBSD manual
download PDF document: snd_atiixp.4.pdf
SND_ATIIXP(4) FreeBSD Kernel Interfaces Manual SND_ATIIXP(4)
NAME
snd_atiixp - ATI IXP bridge device driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device sound
device snd_atiixp
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
snd_atiixp_load="YES"
DESCRIPTION
The snd_atiixp bridge driver allows the generic audio driver, sound(4),
to attach to ATI IXP audio devices. This driver supports 16bit playback
and recording, and 32bit native playback and recording.
Runtime Configuration
The following sysctl(8) variables are available in addition to those
available to all sound(4) devices:
dev.pcm.%d.polling Experimental polling mode, where the driver
operates by querying the device state on each
tick using callout(9). Polling is disabled by
default. Do not enable it unless you are
facing weird interrupt problems or if the
device cannot generate interrupts at all.
HARDWARE
The snd_atiixp driver supports the following audio chipsets:
o ATI IXP 200
o ATI IXP 300
o ATI IXP 400
SEE ALSO
sound(4)
HISTORY
The snd_atiixp device driver first appeared in FreeBSD 6.1.
AUTHORS
This manual page was written by Joel Dahl <joel@FreeBSD.org>.
BUGS
The snd_atiixp driver does not support S/PDIF, but implementing it should
be fairly easy if the right hardware is available.
32bit native recording is broken on some hardware.
FreeBSD 14.0-RELEASE-p11 November 29, 2006 FreeBSD 14.0-RELEASE-p11