FreeBSD manual
download PDF document: virtio_scsi.4.pdf
VIRTIO_SCSI(4) FreeBSD Kernel Interfaces Manual VIRTIO_SCSI(4)
NAME
virtio_scsi - VirtIO SCSI driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device virtio_scsi
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
virtio_scsi_load="YES"
DESCRIPTION
The virtio_scsi device driver provides support for VirtIO SCSI devices.
LOADER TUNABLES
Tunables can be set at the loader(8) prompt before booting the kernel or
stored in loader.conf(5).
hw.vtscsi.bus_reset_disable
In the initial QEMU release with VirtIO SCSI support, in-flight
operations were not aborted when stopping the device, rendering
bus reset ineffective. This tunable disables attempts to issue
reset bus commands. The default value is 1.
DEBUGGING
To enable debugging prints from the virtio_scsi driver, set the
hw.vtscsi.X.debug_level
variable, where X is the adapter number, either in loader.conf(5) or via
sysctl(8). The following bits have the described effects:
0x01 Enable informational prints.
0x02 Enable prints for driver errors.
0x04 Enable tracing prints.
SEE ALSO
virtio(4)
HISTORY
The virtio_scsi driver was written by Bryan Venteicher
<bryanv@FreeBSD.org>. It first appeared in FreeBSD 10.0.
FreeBSD 14.0-RELEASE-p6 June 24, 2012 FreeBSD 14.0-RELEASE-p6