FreeBSD manual
download PDF document: libssh2_sftp_write.3.pdf
libssh2_sftp_write(3) libssh2 libssh2_sftp_write(3)
NAME
libssh2_sftp_write - write SFTP data
SYNOPSIS
#include <libssh2.h>
#include <libssh2_sftp.h>
ssize_t
libssh2_sftp_write(LIBSSH2_SFTP_HANDLE *handle,
const char *buffer,
size_t count);
DESCRIPTION
libssh2_sftp_write(3) writes a block of data to the SFTP server. This
method is modeled after the POSIX write() function and uses the same
calling semantics.
handle - SFTP file handle as returned by libssh2_sftp_open_ex(3).
buffer - points to the data to send off.
count - Number of bytes from 'buffer' to write. Note that it may not be
possible to write all bytes as requested.
libssh2_sftp_handle(3) will use as much as possible of the buffer and
put it into a single SFTP protocol packet. This means that to get
maximum performance when sending larger files, you should try to always
pass in at least 32K of data to this function.
WRITE AHEAD
Starting in libssh2 version 1.2.8, the default behavior of libssh2 is
to create several smaller outgoing packets for all data you pass to
this function and it will return a positive number as soon as the first
packet is acknowledged from the server.
This has the effect that sometimes more data has been sent off but is
not acked yet when this function returns, and when this function is
subsequently called again to write more data, libssh2 will immediately
figure out that the data is already received remotely.
In most normal situation this should not cause any problems, but it
should be noted that if you have once called libssh2_sftp_write() with
data and it returns short, you MUST still assume that the rest of the
data might have been cached so you need to make sure you do not alter
that data and think that the version you have in your next function
invoke will be detected or used.
The reason for this funny behavior is that SFTP can only send 32K data
in each packet and it gets all packets acked individually. This means
we cannot use a simple serial approach if we want to reach high
performance even on high latency connections. And we want that.
RETURN VALUE
Actual number of bytes written or negative on failure.
If used in non-blocking mode, it returns LIBSSH2_ERROR_EAGAIN when it
would otherwise block. While LIBSSH2_ERROR_EAGAIN is a negative number,
LIBSSH2_ERROR_ALLOC - An internal memory allocation call failed.
LIBSSH2_ERROR_SOCKET_SEND - Unable to send data on socket.
LIBSSH2_ERROR_SOCKET_TIMEOUT -
LIBSSH2_ERROR_SFTP_PROTOCOL - An invalid SFTP protocol response was
received on the socket, or an SFTP operation caused an errorcode to be
returned by the server.
SEE ALSO
libssh2_sftp_open_ex(3)
libssh2 0.15 1 Jun 2007 libssh2_sftp_write(3)