FreeBSD manual
download PDF document: uvscom.4.pdf
UVSCOM(4) FreeBSD Kernel Interfaces Manual UVSCOM(4)
NAME
uvscom - USB support for SUNTAC Slipper U VS-10U serial adapters driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device usb
device ucom
device uvscom
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
uvscom_load="YES"
HARDWARE
The uvscom driver supports the following adapters:
o DDI Pocket Air H" C@rd
o DDI Pocket Air H" C@rd 64
o NTT P-in
o NTT P-in m@ster
DESCRIPTION
The uvscom driver provides support for the SUNTAC Slipper U VS-10U chip.
Slipper U is a PC Card to USB converter for data communication card
adapters.
The device is accessed through the ucom(4) driver which makes it behave
like a tty(4).
FILES
/dev/ttyU* for callin ports
/dev/ttyU*.init
/dev/ttyU*.lock corresponding callin initial-state and lock-state
devices
/dev/cuaU* for callout ports
/dev/cuaU*.init
/dev/cuaU*.lock corresponding callout initial-state and lock-state
devices
SEE ALSO
tty(4), ucom(4), usb(4)
HISTORY
The uvscom driver first appeared in FreeBSD and later in NetBSD 1.6.
This manual page was adopted from NetBSD by Tom Rhodes
<trhodes@FreeBSD.org> in April 2002.
FreeBSD 14.0-RELEASE-p11 April 26, 2017 FreeBSD 14.0-RELEASE-p11